It is a high-quality, single-component acrylic adhesive for wall and floor coatings with zero slip. The product is characterized by high adhesion to all surfaces. After drying, it forms a waterproof, durable glue joint. Withstands heavy loads and deformations and ensures durability of bonding. The product is environmentally friendly and does not contain solvents. Made according to European quality standards.
NOTE: It is important that the surfaces to be bonded are well cleaned, dried and degreased. One of the surfaces must necessarily have a fibrous or porous structure with a high absorption capacity of the mounting elastic adhesive. To ensure good adhesion, highly porous surfaces should be primed in advance.
The adhesive can be applied evenly or a toothed spatula can be used. The choice of mounting method depends on the type of surfaces to be bonded. The materials to be bonded should be connected to each other and held in this position for a few minutes. A wet cloth can be used to remove excess adhesive before hardening. Hardened product droplets are removed mechanically.
Gluing is recommended to be carried out at an air temperature not lower than +10 ° C and relative humidity of about 80%.
CONSUMPTION: 200-800 g/m² depending on the condition of the surface of the material to be glued and the method of application.
SAFETY: The glue is fire- and explosion-safe. In case of contact with skin flush with of water and in case of contact with eyes flush with plenty of water and if necessary, seek medical advice.
DRYING TIME: 12 hours at 20°C.
COMPOSITION: styrene-acrylic dispersion, modifiers, adhesion promoters, fillers.
Storage: Glue should be stored in a tightly closed factory container at a temperature of +5 - +30 ° C, away from heat sources, open fire, avoid direct sunlight. To preserve the original properties of the adhesive it is important to prevent freezing. Dispose of the product remnants in closed containers in places of organized collection of household waste.